Directions: 

 

 

How to Measure Your Locs:

Generally, we all have locs of slightly different sizes.  Pick a loc to measure.  Take a yellow number #2 pencil and hold the pencil directly behind the pencil in order to compare the diameter of your loc to the pencil.  If you loc is smaller than the pencil then you will need a size small (unless you have sisterlocks).  But if your loc is larger than the pencil then you will need a large, or if its much larger than the pencil consider ordering an extra large.

 

How to put them on:

Find a loc, dreadlock, braid or twist that is approximately the same width as the coil, and gently push it through the opening on the top or bottom. Twist gently* until the end of your hair passes through the coil and gently pull through to your desired position. 
*If the coil is too tight on your hair DO NOT force it, try another section of hair, this should gently glide over the hair. 

 

Sisterlocks & Loose Hair:

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Open the threader a little and put the end of the hair your would like to add the bead to in the threader.  Then put the end of the threader (with your hair in it) in the hole of the bead and pull through.  Your bead should be on your hair. It it feels loose on your hair, you could put the bead on a bigger section of hair or your can tie a small hair rubber band underneath the bead.  The bead will stay on the hair by it self if it fits snuggly on the hair.